Solutions to the uneven surface of the mold, the whitening of the bone position ...
How can the frequent breakage of the water inlet needle of the mold, the raised bone position and the excessive glue on the side (flash) be solved
How can the frequent breakage of the water inlet needle of the mold, the raised ...
Solutions to the problems of air streaks, exposed glass fibers and charring in molds
Solutions to the problems of air streaks, exposed glass fibers and charring in m...
Solutions to the problems of column bending deformation, delamination, surface peeling and frequent pressing of small spouts in the mold
Solutions to the problems of column bending deformation, delamination, surface p...
How to solve the problems of whitening, charring and deformation of the bone position at the water outlet of the mold
How to solve the problems of whitening, charring and deformation of the bone pos...
Solutions to the problems of pin tip, pin shrinkage and trapped air fracture in molds
Solutions to the problems of pin tip, pin shrinkage and trapped air fracture in ...
Solutions for mold clamping lines, surface clamping marks and clamping position sticking to the mold
Solutions for mold clamping lines, surface clamping marks and clamping position ...
Solutions for air streaks, charring, wire jamming, height elevation or trapped air in molds
Solutions for air streaks, charring, wire jamming, height elevation or trapped a...
Solutions to wire clamping, surface indentation and punch marks in molds
Solutions to wire clamping, surface indentation and punch marks in moldsThe clam...
The solutions for the air marks at the arrow position in the mold direction, the black shadow lines (fusion lines) on the surface, and the trapped air and white spots at the lamp hole position
The solutions for the air marks at the arrow position in the mold direction, the...
The grooves of the mold's injection air inlet, the surface light and shadow, the scratches on the grooves and the size of the screw holes have increased
The grooves of the mold's injection air inlet, the surface light and shadow, the...
Solutions to the problems of wire clamping, clamping position pull-over deformation and air marks in molds
Solutions to the problems of wire clamping, clamping position pull-over deformat...
The trapped air adjustment of the mold is difficult, and the deformation and the bottom row position pulling mold treatment method of the face shell
The trapped air adjustment of the mold is difficult, and the deformation and the...
The solution to the problem of the lens length dimension of the mold being too large and the water line being clamped on the side of the middle hole position
The solution to the problem of the lens length dimension of the mold being too l...
Solutions for trapped gas burning, surface wire clamping and insufficient glue in the inner column of the mold
Solutions for trapped gas burning, surface wire clamping and insufficient glue i...