News

The solution to the obvious flash and ejector pin marks at the water passage pos...

Solutions to air streaks and incomplete filling (lack of glue) in moldsThe air s...

Treatment methods for mold weld marks/shrinkage marks and fracturesMold weld mar...

Solution for mold fracture and air wrinkle treatmentFracture of the moldPhenomen...

The screw columns of the mold are prone to damage and weld marks/shrinkageThe sc...

Methods for the easy breakage of the internal position of the mold and the easy ...

The glue inlet position of the mold is dragged and charredThe glue inlet of the ...

The U-shaped position of the mold is filled with water lines and trapped air, wh...

How to solve the problems of surface dents and mold on injection moldsConcave po...

The drawing of the mold and the inking of the gateMold drawing Phenomenon: Th...

The mold case integrates lines and exposed whiteMold fusion line：Phenomenon: The...

The surface baking printing and light and shadow of the moldSurface baking and p...

The surface of the mold is baked and printed bright and has surface flow marksTh...

Wire clamping and air marks near the screw holes of the mold Phenomenon: Wire...

The methods for adjusting parameters for defects in injection molded products ar...